A 6000K (Nice crisp pure white) HID 35 watt lamp outputs about 2.5 times more than the 35 watt stock halogen lamp. There is a YouTube install video for this which is very helpful except I totally disagree with not bothering to disconnect the battery or handling the HID bulbs with anything other than gloves. Apart from that the kit was well presented and represented much better value for money than the LED kit at around $100.00 cheaper with many more parts. The seller from Alpine MSS was co-operative on this and assured in future these would be soldered. It turned out this was wire wrapped and not soldered on my install and another one I did. There is a “dummy load resistor” on these to stop lamp fail errors. Wiring also has to be tucked under the Snap-On headlight cover cap. HID Version: More work fitting and require fitting of an external relay plus two ballasts. It’s hard to get a good light output on the M3 due to the design of the headlights unlike other cars like Audi that have front facing individual LEDs Look great around dusk but have fairly low output as a true daylight running light. Not very bright, not much more than stock if that. They also draw very little power compared to the regular 35 watt H8 lamp and are around the same brightness. At 10 watts they run fairly cool and an LED has a very long life expectancy. Relatively easy to fit, are completely enclosed in the headlamp enclosure and require no external connection to the battery supply. The manufacturer was very keen to co-operate and committed to improving. ![]() There was no in- line fusing on these which is a real worry if they fail short. The wire quality was not what you expect hook up wire rather than silicone coated high temperature wire. The controller module failed on over temperature constantly and the wiring had to be extended enough to be able to place this at the bottom of the headlamp housing where it was much cooler. I did not like the wire harness that came with this model and had to completely rework it. They plug straight in to the factory connector which goes to a small controller, then to the LED H8 assembly. This was a 10 watt LED mounted rear facing on an aluminium block and a bolt on heatsink. Very easy to fit, although the AngeliBright was a bit of a pain with the heatsinks. There are pros and cons for both, so I’ll list what I found and would be very interested to hear of others with experiences of either. As I’ve mentioned before my background is Electronic Engineering so this was a fairly easy install for me. I’ve had both now and am running the HID’s I got from Alpine MSS, USA also had a set of AngeliBright version 3 -10 watt LEDs. ![]() Hi Everyone, thought this topic may be of interest as Angel eyes seem to be quite a common add on and quite easy to do.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |